Refurbishing service
After intensive use, plates start to display signs of wear, which can lead to reduced quality and productivity - which is where C.A.PICARD® comes into play. With our in-house service backed by many years of experience in the area of grinding technology, we can restore the surface of the plates to as-new condition to maintain your productivity at a constant high level.
To do this, C.A.PICARD® operates service centres worldwide where your tools will be ground and straightened quickly, precisely and cost-effectively. We can also provide this service for third-party products.
Our refurbishing service is available for the following wear parts:
- Press plates
- Separator plates
- Carrier plates
- Top and bottom plates
- Die cutting plates
- Slide plates
- Vulcanisation moulds
- and much more
Technical characteristics of refurbishing:
| Refurbishing service | |||
|---|---|---|---|
| Grinding type | Stone grinding (N7) | Belt grinding | Finishing (Finish 6) |
| Max. length | 3850 mm | 5300 mm | 3800 mm |
| Max. width | 1730 mm | 1780 mm | 1600 mm |
| Surface finish | N7 (Ra 0.8-1.6 µm) | ||
Extend the lifespan of your wear parts with our refurbishing service.